Where crumb rubber fits in a playground
Recycled rubber shows up under playground equipment in two main forms:
- Unitary surfaces, such as poured-in-place (PIP) rubber and bonded tiles. Crumb granules are mixed with a binder and troweled or molded into a continuous surface.
- Loose-fill rubber, such as rubber mulch or nuggets, spread to a depth and kept in place with containment.
We supply the granules used to build unitary surfaces, typically for the cushioning base course. (We don't sell rubber mulch.)

The standards that matter
The finished surface, not the raw crumb, is what gets judged. The standards installers and owners rely on:
- ASTM F1292, Standard Specification for Impact Attenuation of Surfacing Materials Within the Use Zone of Playground Equipment. This is the impact test that establishes a surface's critical fall height.
- ASTM F2479, Standard Guide for Specification, Purchase, Installation and Maintenance of Poured-In-Place Playground Surfacing. Covers drainage, transitions, aging, cracking and repair.
- ASTM F3012, Specification for Loose-Fill Rubber for Use as a Playground Safety Surface, for loose-fill rubber products.
- The CPSC Public Playground Safety Handbook, which discusses surfacing selection, depth and maintenance for public playgrounds.
Bottom line: crumb size and quality matter for workability and durability, but safety performance belongs to the installed system and its testing. Buy crumb to the installer's or system manufacturer's spec.
Typical grades
| Layer | Commonly used crumb | Notes |
|---|---|---|
| Base / cushion course | 10-20, 8-16, ABR | Coarse granules bound with polyurethane; thickness set by fall-height design |
| Wear / top course | Usually colored EPDM or TPV granules (not tire crumb) | Bought separately from color suppliers |
| Bonded tiles | 10-20 core, finer face | Molded off-site |
Worked example
Base course for a 2,500 sq ft play area
Base thickness is set by the installer's system to meet the critical fall height under ASTM F1292, so the crumb quantity comes from the installer's mix design. Here's how to turn that design into an order:
- Suppose the installer's design calls for 3.0 lb of crumb per sq ft of base at the chosen thickness
- 2,500 sq ft × 3.0 lb = 7,500 lb of 10-20 mesh, about 4 supersacks
- Three or four similar sites in a season? Put them on one truck and stage deliveries
Swap in your system's actual lb/sq ft figure. The point is: one truckload covers a lot of playground.
Installer? Get granules priced to your yard. Send grade, volume, delivery city/ZIP and your target price.
Request a QuoteWhat installers should spec
- Size range and sieve method (ASTM D5644)
- Residual steel limit (wire fragments are a no-go on a playground)
- Fiber and dust limits
- Moisture limit (isocyanate binders react with water)
- Packaging that fits your trailer: supersacks with or without pallets
Frequently asked questions
What crumb rubber size is used for poured-in-place base?
Coarse granules like 10-20, 8-16 or ABR are common for base courses. Your system manufacturer's spec governs.
Does your crumb rubber meet ASTM F1292?
F1292 tests the finished, installed surface, not the raw granules. The installer's system and its testing establish compliance.
Do you sell rubber mulch for playgrounds?
No. We sell crumb rubber granules for bound systems.





